| Technical Data |
SDO2072 |
SDO2102X |
SDO2202X |
| Real-time Sample Rate |
2500MS/s |
1GS/s |
1GS/s |
| Equivalent Sampling Rate |
50GS/s |
| Average Sampling Times |
2,4,8, 16, 32, 64, 128 and 256 |
| Input Channel Specifications |
| Input coupling |
DC, AC, GND |
| Input Impedance |
(1MΩ±2%)//(18pF±3pF) |
| Probe attenuation coefficient |
0.01x/0.02×/0.05×/0.1×/0.2×/0.5×/1×/2×/5×/10×/20×
50×/100×/200×/500×/1000× |
| Maximum input voltage |
300 Vrms, the transient over voltage is 1000 Vpk. |
| Horizontal System Specification |
| Time-base scale |
2ns/div-50s/div |
| Waveform interpolation |
Sin(x)/x |
| Time-base accuracy |
≤±(50+2×service life)ppm |
| Record length |
2×512k sampling point |
| Storage depth |
Single channel: 64kpts, Double channel: 32kpts |
| Sampling rate and delay time accuracy |
±50ppm (any time interval≥1ms) |
Measurement accuracy of
time interval (△T) |
Single : ±(1 sampling time interval + 50ppm x reading + 0.6ns)
>16 average values: ±(sampling time interval+50ppmXreading+0.4ns) |
| Waveform capture rate |
5,000 wfms/s |
| Vertical System Specification |
| Analog Bandwidth |
70MHz |
100MHz |
200MHz |
| Rise Time(Typical) |
≤7ns |
≤3.5ns |
≤1.8ns |
| Channels |
2 |
| Analog-to-digital converter (A/D) |
8 bits |
| Deflection factor range |
1mV/div~20V/div(1MQ) |
| Position range |
≥±8div |
| (Typical) limitation bandwidthSelectable |
20MHz |
Low frequency response
(AC Coupling, -3dB) |
≤5Hz(above BNC) |
| DC gain accuracy |
5mV~20V/div:≤±3%,1mV~2mV/div:≤±4% |
| DC measurement accuracy |
When vertical position is 0 and N≥16:
±(4%Xreading+0.1div+1mV) and selects 1mV~2mV/div;
±(3%Xreading+0.1div+1mV) and selects 10mV~20V/div
When vertical position is not 0 and N≥16:
±(3%×(reading + vertical position reading) +
(1%Xvertical position reading)+0.2div);
The setting from 5mV/div to 200mV/div plus 2mV,
the setting value from 200mV/div to 20V/div plus 50mV |
Measurement accuracy of
voltage difference (△V)
(average sampling mode) |
Under the same setting and environment conditions and
after averaging the captured waveforms with a quantity of
≥16, the voltage difference ( △V) between any two points on
the waveform: ±(3%Xreading+0.05div) |
| Trigger System Specification |
| Trigger sensitivity |
≤1div |
| Range of trigger level |
Int: From the screen center ±10div, Ext: ±3V |
Trigger level accuracy (typical)
(Signal with rising and falling time≥20ns) |
Int: ±(0.3divXV/div) (within±4 div from the screen center)
Ext:±(6% setting value+40mV) |
| Pre-trigger capacity |
Normal mode/scan mode, pre-trigger/delay trigger
the pre-trigger depth is adjustable |
| Hold-off range |
80ns~1.5s |
| Set the level to 50% (Typical) |
Operate under the condition of input signal frequency of ≥50Hz |
| Trigger mode |
Auto, Normal, Single, Edge, Pulse, Video, Slope |
| High-frequency hold off |
Hold off signals over 80kHz |
| Low-frequency hold off |
Hold off signals below 80kHz |
| Measurements |
| Cursor |
Manual mode |
Voltage difference between cursors (△V),
Time difference between cursors (△T),
Reciprocal of Δ Τ (Hz) (1/ΔΤ) |
| Track mode |
waveform of point of value time and valueVoltage |
| Auto mode |
Cursor display is allowed on auto measurement mode |
| Automatic measurement |
Max, Min, High, Low, Ampl, Pk-Pk, Middle, Mean, CycMean, RMS,
CycRMS, Period, Freq, Rise, Fall, RiseDelay, FallDelay, +Width, -Width,
FRFR, FRFF, FFFR, FFFF, FRLF, FRLR, FFLR, FFLF, +Duty, -Duty,
Area, CycArea, OverSht, PreSht and Phase. |
| Measurement quantity |
Display 5 types of measurement at the same time |
| Measurement scope |
Screen or cursor |
| Math |
| Math operation |
+, -, x, + |
| Window |
Rectangle, Hanning, Blackman, Hamming |
| Vertical scale |
Vrms, dBVrms |
| Digital filtering |
Low pass, High pass, Band pass, Band reject |
| Trigger frequency meter |
| Reading resolution |
6bits |
| Trigger sensitivity |
≤30Vrms |
| Accuracy (Typical) |
±51ppm (+1 character) |
| Storage |
Internal: 20 groups. USB: 200 groups |
| Display |
7-inch 800X480 color LCD |
| Interface |
Standard: USB Host, USB Device, EXT Trig,Pass / Fail. Option: LAN |
| Power |
100V~240VACrms, 50/60Hz, CAT II |
| Size |
306mm(W)×138mm(H)X124mm(D) |
| Weight |
2.5kg |
